Drum gear cardan universal shaft coupling products how to solve the circle swing

Drum gear cardan universal shaft coupling productsThe solution for circle swing is as follows:

1. Check whether the shaft tube of Drum gear cardan universal coupling products has bumps and dents, and whether the balance sheet is lost. The loss of the balance piece requires re-soldering the same balance piece at the original solder joint position. If the universal coupling shaft tube has obvious depressions and the universal coupling itself is out of balance, the spline shaft and Drum gear cardan universal shaft coupling products fork should be cut off on the lathe, and a larger than shaft tube should be inserted into the shaft tube. Shafts with a thin inner diameter are repaired by hammering on the recesses. The cut spline shaft and cardan shaft are then fork welded in place.

2. Check whether the flange connection bolts of Drum gear cardan universal coupling products are loose, and tighten them as appropriate.

3. Remove the drive shaft assembly and perform a balance test on the balancing machine. When the unbalance is very poor, balance compensation should be performed.

4. Check whether the expansion joint is installed according to the standard mark. If the installation is correct, support the car body and start the engine to run at idle speed and low gear. If the swing amount of the Drum gear cardan universal shaft coupling products is large, you can measure the deflection position and direction with a needle. , yaw amount, if the two ends of the drive shaft are not straight or bent, the soft metal that matches the shaft tube should be placed on the pressure strip for cold pressing correction. When the vibration of Drum gear cardan universal shaft coupling products occurs, the corresponding solution should be selected according to the cause to eliminate it.