Mobile QR code
Address: No. 301, Xujia Village, Jingxi Town, Minhou County, Fuzhou City, Fujian Province, China
Fuxing Avenue, Jinan District, Fuzhou City, Fujian Province, China
Mobile phone: +86 591 83629866、83622555
Fax：+86 591 83629866、83622555
Features and process of steel hot wire rod rolling mill production line
The steel pusher is a special equipment for pushing the steel billet into the heating furnace for heating on the steel hot wire rod rolling mill production line. For example, the heating furnace equipment of a factory has a heating furnace width of 9.128m and a length of 30.856m. The maximum billet length allowed to be pushed is 9m, width 1.1m, and thickness 20cm. m/s, the two push rods have left and right single action and linkage working modes. The steel pusher pushes the steel billets into the heating furnace one by one, so that up to 30 pieces of steel can be heated in the furnace at the same time, so when the two push rods are linked to push steel into the furnace, the two push rods must be kept in sync. Make sure that the steel billet enters the heating furnace horizontally, otherwise a piece of steel is inclined, and the accumulated inclination will cause the whole furnace to incline, and even the steel hot wire rod rolling mill production line will be shut down due to steel turning and furnace scraping.
Structural features of steel hot wire rod rolling mill production line: Mechanical type steel pushing machine is composed of motor, reducer, mechanical transmission part, shell, etc. Its main features are stable rolling, large thrust, and can push double rows of billets. The hydraulic pusher consists of a hydraulic cylinder, a hydraulic pump station, a balance push rod and a base. Its main features are: simple structure, high thrust, low cost, and it can also push double rows of billets.
Old-fashioned production lines often use mechanical pushers, which are large in size, high in price, high in failure rate, and complicated in maintenance. With the development of steel hot wire rod rolling mill production line production, the new hydraulic steel pusher has gradually replaced the old mechanical steel pusher, making full use of the advantages of large thrust, small size and convenient operation of the hydraulic cylinder and hydraulic system, making the pusher The material process is greatly simplified, and the equipment cost is greatly reduced, which is very popular among users.