Laying head Used for Wire Rod Rolling Mill Production Line factory introduces the causes of common machine problems

Laying head Used for Wire Rod Rolling Mill Production Line factory will introduce to you: the wear and tear of spinning related equipment will also cause large and small rings, you should check the wall thickness of the spinning tube, the pinch roll outlet bend, the double module mill unit to the clamp The wear and tear of the guide groove between the feeding rollers and the cooling water pipe of the cooling water tank should be adjusted in time;

Laying head Used for Wire Rod Rolling Mill Production Line factory will introduce to you: the wear and tear of spinning related equipment will also cause large and small rings, you should check the wall thickness of the spinning tube, the pinch roll outlet bend, the double module mill unit to the clamp The wear and tear of the guide groove between the feeding rollers and the cooling water pipe of the cooling water tank should be adjusted in time; in addition, large and small circles will also appear due to improper electrical automation control and improper adjustment of rolling line tension, and relevant necessary measures should be taken.

Laying head Used for Wire Rod Rolling Mill Production Line factory can also tell you: if the machine is not round. The out-of-round spinning circle is due to the fact that after the rolling line is changed, the spinning tube is not replaced or the dynamic balance is damaged after the spinning tube is worn, and the dynamic balance test is not carried out after the new spinning tube is replaced. It should be checked regularly and carried out during installation. Spinning maneuver balance test.