Emulsion pump head company introduces product performance

Laying head Used for Wire Rod Rolling Mill Production Line factoryIntroductionProduct FAQ analysis Laying head Used for Wire Rod Rolling Mill Production Line factory will introduce to you: The hollow shaft of the laying machine is generally positioned axially by two disc angular contact ball bearings, the floating end is supported by a disc cylindrical roller bearing for radial force, and the transmission gear Located on the end of the hollow shaft close to the axial positioning bearing.

Laying head Used for Wire Rod Rolling Mill Production Line factoryIntroductionProduct FAQ analysis

Laying head Used for Wire Rod Rolling Mill Production Line factory will introduce to you: The hollow shaft of the laying machine is generally positioned axially by two disc angular contact ball bearings, the floating end is supported by a disc cylindrical roller bearing for radial force, and the transmission gear Located on the end of the hollow shaft close to the axial positioning bearing. The purpose of this design is to minimize the change of the gear clearance caused by the expansion of the hollow shaft due to heat when it is working, thereby affecting the transmission effect.

Analysis of Spinning Loop Problem of Silk Laying Machine

1. The reason why the spit circle fluctuates left and right is that when the coil spits out and falls at the outlet of the spinning pipe, there is a speed in the tangential direction of the coil. Technically, the speed advance value of the laying head and pinch roller should be adjusted to make the laying coil fall smoothly and evenly.

2. Laying head Used for Wire Rod Rolling Mill Production Line factory will introduce to you: the spinning rings are of different sizes. Due to the continuous wear of the laying tube wall, the dynamic balance of the laying machine is destroyed, and the spinning process may be blocked due to wear. Therefore, the wear resistance requirements of the laying tube should be improved, and the speed of the laying machine should be reduced; Improper installation of the spinning tube, high temperature spinning, deformation and displacement of the spinning tube will also cause large and small circles, and should be installed strictly.

Our company is a professional Laying head Used for Wire Rod Rolling Mill Production Line factory, if necessary, please contact us.