What to do when Steel Rolling Mill Machines and hot-rolled strip steel are in poor condition

In the whole process of the application of Steel Rolling Mill Machines, there will be many bad conditions that will cause serious results. If we are not particularly familiar with Steel Rolling Mill Machines, then there is no doubt about this type of problem. In order to better ensure the quality of the products produced and processed by Steel Rolling Mill Machines at the forming level, it is also to better and more reasonably increase the service life of Steel Rolling Mill Machines in applications. Explain in this article.

Steel Rolling Mill Machines have two common safety hazards: piled steel and stuck steel. At this moment, everyone only has to extend the top roll of Steel Rolling Mill Machines quickly, and immediately cool the hot-rolled steel strip. Because only when the temperature is relatively low, everyone can terminate it and start a reasonable solution, but if the hot rolled strip steel of Steel Rolling Mill Machines is already operating under the condition of no water cooling If it takes a longer period of time, then everyone must disassemble and assemble all the hot-rolled strip steel, mainly to better enable it to carry out a slower refrigeration. If the cooling cycle water is used immediately for refrigeration, then The adverse effects it causes will be very serious.

And in the whole process of all cold rolling of Steel Rolling Mill Machines, the most common occurrence should be the air oxide film. If we have been conniving and do not handle it properly, then when the air oxide film has a certain thickness, the air oxide film will be All of them fall off and will produce a variety of different shortcomings in the hot-rolled strip tank. Therefore, whether it is hot-rolled strip or Steel Rolling Mill Machines, the result of all applications depends on how everyone uses it.